Part Number: AX-AB-CH2
Details
Your factory amplifier is designed to only work best with your original factory sound system and has pre-set limitations set by the vehicles manufacturer through the radio. This means you would not get the optimal sound you want from your aftermarket gear. If your vehicle has a built-in digital amplifier and you will be installing upgraded aftermarket speakers or subwoofer, then you will need to bypass your factory amplifier to an aftermarket amplifier. Axxess has simplified bypassing your factory amplifier with our AXABH series in taking all of the guesswork out of you having to figure out the wiring and providing a clear wiring chart with clearly labeled wires. The AXABH series is also a great solution if your factory amp has gone bad and you need to install an aftermarket one . Don’t forget to check our Vehicle Fit Guide to see if an AXABH harness is available for your vehicle as these products are dependent on the vehicle application.
- Allow the factory amplifier to be bypassed without altering the factory wiring.
- 20 gauge wires
- Length – 12 inches
Applications
- Chrysler
- 200 2015-2017 , Amplifier Location: Passenger Dash, Up High. (Behind Glovebox).
- 300 2011-2014 , Amplifier Location: Driver Kick, Left of Steering Column.
- Town & Country 2008-2020 , Amplifier Location: Left rear corner panel
- Caravan/Grand Caravan 2008-2020 , Amplifier Location: Left rear corner panel
- Charger 2011-2014 , Amplifier Location: Driver Kick Panel.
- Dart 2013-2016 , Amplifier Location: Behind glovebox
- Durango 2014-2020 , Amplifier Location: Driver Side Trunk, Behind Wheel Well.
- Journey 2011-2020 , Amplifier Location: 2009-2010: Behind Glovebox ; 2011-Up* Under Passengers Seat.
- Nitro 2007-2011 , Amplifier Location: Left rear corner panel
- Cherokee 2014-18
- Cherokee 2019-up (Without Active Noise Control (ANC))
- Compass 2017.5-Up
- Grand Cherokee (Base Amp) 2011-17
- Liberty 2008-2012
- Wrangler 2007-2017
- 1500/2500/3500 2013-18
Dodge
Jeep
Ram
